
Washer not draining in Ridgewood
Standing water in a Ridgewood basement
Ridgewood basements between Glen Rock, Ho-Ho-Kus, and Midland Park usually send the washer hose into a standpipe, not a sink. Stuffing that hose too far down the pipe can stop a drain as surely as a dead pump. Bi-State Appliance Service can tell those apart. The first look is only the hose you can see.
The first visit is a diagnostic: $150 + tax. If you proceed with the repair, the diagnostic is applied toward the repair.
What you can check safely
Hook the hose on the standpipe, do not jam it down
The end should hang in the opening, not disappear a foot into the pipe. Pull it up if you shoved it in after a move.
Do not snake the standpipe yourself
A basement floor and a full washer is a bad place to learn a snake. Leave the pipe.
Keep the basement floor drain clear of the puddle path
If water is already out of the machine, stop the cycle. Mop what you can reach. Do not add rinse water.
When to call
Call 201-835-9187 when the hose is seated correctly and the tub still will not empty. Bi-State Appliance Service will test the pump on a diagnostic.
Washer not draining in general · Washer repair · Appliance repair in Ridgewood
Frequently asked questions
I pushed the hose deep into the Ridgewood standpipe. Could that be it?
Yes. Pull it back so it only hooks into the opening, and try one drain. If the tub stays full, book.
The washer drains halfway and stops.
That is still a drain failure. Tell Bi-State Appliance Service it gets partway and quits.
What is the diagnostic?
The first visit is a diagnostic: $150 + tax. If you proceed with the repair, the diagnostic is applied toward the repair.
